Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> What crank keys do I use for SBC crank?
User Name
Password
lost password?   |   register now

Thread: What crank keys do I use for SBC crank? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-08-2009 07:36 PM
406 bug As boogie states they need to be tight. After you install them in the crank, make sure you measure the height of the key in relation to key way depth of the balancer. I found the key way on my scat crank was not machined to the proper depth so it was necessary to mill a bit off the top of the keys. This can be accomplished with the keys in place.
02-08-2009 07:11 PM
GMC boogie I don't know the exact size. I use a hammer and brass punch to drive them in. Thay should not just fall in place.
02-08-2009 05:04 PM
eric32
What crank keys do I use for SBC crank?

Hello guys I just bought a brand new scat cast steel crank 3.480 crank for a 1 piece rear main seal 350 small block. I bought a set of woodruff keys at advance auto today and I know I need two of them by looking at my crank. I am guessing looking at the crank slots it would take the bigger ones but know the exact size ones to use. It came with the following ones 3/32 by 1/2 inch,1/8 by 1/2 inch, 5/32 by 5/8 inch, 1/8 by 3/4 of an inch, and the last one3/16 by 3/4 of an inch. Also how do I install them cause I have never done one before. Do I just tap them in with a rubber mallet very gently or do they just kind of sit in there a little snug but not too tight?

Thanks
Eric

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:23 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.