Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> chevy 350 to trans am motor mounts
User Name
lost password?   |   register now

Thread: chevy 350 to trans am motor mounts Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-08-2009 07:27 PM
JohnyR17 Usually this is a bolt in swap.

I swapped a 301 out of a '79 Firebird and replaced it with a 400 chevy. For whatever reason the passenger side of the crossmember was drilled for chevy motor mounts and the drivers side was not.

Do as suggested, bolt the upper and lower motor mounts to the block and lower the engine into the car. If the appropriate holes are there, its a bolt in deal. Otherwise, scribe the location carefully and drill new holes.
03-08-2009 06:43 PM
Originally Posted by poncho62
Use Camaro mounts....same frame
Yes. The 70-81 Camaro and Firebirds use exactly the same subframe. The subframes are already drilled for the motor mounts. This is a bolt-in.
03-08-2009 01:15 PM
poncho62 Use Camaro mounts....same frame
03-08-2009 12:51 PM
dedub A technique I have used but not on a trans am is to bolt the motor to the tranny, place it on the crossmember and bolt it in, then lower the motor (WITH the Chevy motor mounts) down, Where they land is where you drill holes. You may be lucky and there will be holes pre drilled, going from a B.O.P set up to a chevy shouldn't be that far off.
03-08-2009 12:42 PM
chevy 350 to trans am motor mounts

i have a 77 trans am and a recently purchased chevy 350 from an 80-85 truck to put in it, are there any websites that would have the correct motor mounts id need that would fit my motor and bolt into the frame? thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 03:56 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.