I have a 2000 Jeep Wrangler 4x4 and 4.0 engine with the automatic trans (3 speed/no over drive).
The trans changes gears 1st to 2nd fine but from 2nd to Drive it seems to take a lot longer to finally shift .Sometmes 3000 rpm or more.
I changed the trans filter and put in the +4 atf that is required as well as Lucas trans additive but it still act up.
It seems to shift better after everything warms up.
The trans holds well in all gears with no slipping once it is in each gear.
Any ideas before It goes to the shop tomorrow?
The trans changes gears 1st to 2nd fine but from 2nd to Drive it seems to take a lot longer to finally shift .Sometmes 3000 rpm or more.
I changed the trans filter and put in the +4 atf that is required as well as Lucas trans additive but it still act up.
It seems to shift better after everything warms up.
The trans holds well in all gears with no slipping once it is in each gear.
Any ideas before It goes to the shop tomorrow?