Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> How do I put on a starter brace on a 350 sbc?
User Name
Password
lost password?   |   register now

Thread: How do I put on a starter brace on a 350 sbc? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-19-2009 08:58 AM
dirtinla Has anyone made homemade brackets... if so please post a pic of what you did... I would like to do this.
05-18-2009 07:44 PM
poncho62 Not sure....it would likely have to be longer....ask where you get the mini starter
05-18-2009 07:36 PM
eric32 Hey cool thanks guys will these braces work on aftermarket mini starters as well? Thanks again
Eric
05-18-2009 07:29 PM
HarryT
Starter Brace

The rear of the starter has one bolt that is longer than the others. One end if the brace attaches to this bolt. The other end of the brace bolts to the engine block via a threaded hole in the block located just below the block/head joint.
05-18-2009 07:28 PM
poncho62 If you are talking about a stock starter, the brace goes from one of the long bolts that holds the starter motor onto the housing to a boss on the side of the engine block under the head, just behind the motor mount. Look at the bottom of this diagram.

05-18-2009 07:01 PM
eric32
How do I put on a starter brace on a 350 sbc?

Hello guys I have been reading about how your supposed to use a starter brace on 350 small block chevy. I currently have two trucks with 350's in them and neither one has a starter brace on them. The 86 s10 I have has a gear drive starter on it and my dad said I don't need one since it does not pull as hard as a torque drive starter. My other 96 s10 has a plain old torque starter and I don't want to risk damaging my new 350 to put in it this weekend. I will eventually get a gear drive for it when funds permit but for the time being I will use whats on it. But the question I have looking at a picture of one on summit's website I can't tell how it goes on. Any help or photos would be nice. Thanks for help guys.
Eric

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:25 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.