Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Building Headers, Exhaust port exit angle question
User Name
Password
lost password?   |   register now

Thread: Building Headers, Exhaust port exit angle question Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-15-2009 10:44 PM
Rustydawg Interesting project you have there.

Your thinking is sound, it is beneficial to maintain the exit angle of the exhaust port, and seeing that you have room for it, why not? I would assume that anything that salvages as much heat and velocity from the port is good for the turbo.

My guess is that the factory created that exit angle in the interests of efficiency, it is straighter than the 90 degree bend in 'exhibit A'.
06-15-2009 12:47 PM
mkloter
Building Headers, Exhaust port exit angle question

As the title says, building 304 tubular headers for 97 Pontiac turbo v6 (not GN motor) converted from FWD to RWD

I was looking at the usual:

Courtesy of standard abrasives
As you can see the exhaust port exits the head perpendicular to the flange mating surface

However on the ported heads I am using for my project (Iron heads on the right):

Courtesy of zzperformance
The exhaust ports exit at an angle of about 22 degrees from the flange mating surface.

I was thinking that it would be beneficial to exhaust flow if the primaries were welded to the flange at the same angle as the the exhaust runners so there would not be a sudden sharp turn right at the transition.

My question to everyone here is is my logic sound or is there a veriable I am missing here ie: the exit angle is there to prevent exhaust reversion etc

I have plenty of room in the engine compartment (best pic I have on hand)



I think its about a foot on either side

Thanks for the help
Mike

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.