Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> 350 sbc pistons
User Name
Password
lost password?   |   register now

Thread: 350 sbc pistons Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-08-2009 05:02 PM
techinspector1 I think you'd have about as much luck as trying to make a Ford piston work in the Gen I.

Gen I 350
1.560" compression height
0.927" wrist pin diameter

Gen III, IV
1.338" compression height
0.945" wrist pin diameter

I don't think the valve reliefs will line up either.

I've done this kind of hokey stuff in the past and have ended up spending more money than if I had used the correct parts in the first place. Sell those pistons to someone who needs them and start fresh is my best advice to you.
09-08-2009 05:01 PM
GMC boogie Gen 3 Stock LS1 bore is 3.908. Gen 1 Stock 350 bore is 4.00.

It's gonna rattle a bit.
09-08-2009 04:41 PM
Thumpr Yes thats what it says. Taking it to a machine shop is no problem. If they will be able to tell me the difference in the pin heights. Just figure someone in here would know.
09-08-2009 04:29 PM
whynot Well honestly I am not sure about the stroke. But on the box it says the bore is 4.0300, Which I think a 350 is 4.000 Maybe boring will take care of that. Might have to take it to a machine shop to get the pin height.
09-08-2009 03:45 PM
GMC boogie I don't see how they would work, different bore & stroke combinations betwwen the two.
09-08-2009 02:47 PM
Thumpr
350 sbc pistons

Anyone know the difference in a 80s 350 sbc piston and a LS 350 sbc piston. I was told the can be exchanged. I have a new set of LS pistons and want to put them in my 80s 350. Figured I might even have to go with a stroker crank. Anyone done this swap ?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 05:21 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.