|06-04-2011 11:20 AM|
X2 no series with a 9 inch.
|06-03-2011 07:08 PM|
Some of the performance gear sets already have the inside edge of the ring gear ground so you don't have that problem.
|06-02-2011 04:25 PM|
I have a set of 4.11 gears that are hitting. And if you look in summit racing it does list 3 series carrier.
|10-28-2009 02:26 PM|
|10-28-2009 05:21 AM|
|barnym17||Look under imca in ebay they are common ratios available into the 7 range.When you set up used gears do you adjust the depth by matching the wear pattern?I've just never had any luck with used gears.|
|10-26-2009 10:26 AM|
|10-26-2009 10:05 AM|
3.06 case is LM603049
|10-26-2009 08:55 AM|
|barnym17||Used gears=bad new us gear is available for around $112.00 off ebay good gears.With used if you don't get everything set exactly as it was ran you will have problems.It's like putting used lifters on a cam.The gears are already mated together and being off a little can cause issues.|
|10-24-2009 03:04 PM|
|lmsport||You also have to know the diameter of the bearing stub on your carrier. The old carriers were 1.6__" and the newer ones 1.78". The LM501349 bearing is for the small stub and the LM102949 is for the big stub.|
|10-24-2009 03:01 PM|
|31fordcoupe||I think it's pretty consistent though that the smaller bearing is used for the 28 spline and the larger bearing is used for the 31 spline. I will mic it before ordering. Thanks.|
|10-24-2009 02:54 PM|
You may need to know which carrier bearing you have to get the correct kit.
|10-24-2009 01:50 PM|
Thanx much prostreet. I will bid on the second set then. I also found a Timken rebuild kit on ebay for about $80. So those gears and that rebuild kit and I should be on my way (need axle bearings as well).
I really appreaciate all of your help on this (and every other question you have answered on here for me).
|10-24-2009 01:20 PM|
Why buy used (problems?) when Summit has a set of 4.33's for $160 + $12 shipping or another set for $206 or a third for $266 - all Richmond's. No clue without spending more time with the specs what the differences are, but a used R&P plus the bearings and seals plus labor for something that might have been flogged - hard - just isn't worth the aggravation. I can understand trying to save a few bucks, but not in the engine/driveline where you need as much reliability as you can get. And 50-100 bucks - not worth the possible grief and pain to suffer someone elses problems.
OK - now I'll put my soapbox away and watch the NA$CAR Nationwide race
|10-24-2009 12:54 PM|
|prostreet6t9||If you get the Richmond set they may make a little noise. But thats not a bad buy.|
|10-24-2009 12:41 PM|
|prostreet6t9||Yes! But it's the second one listed. Not on the backside,the backside cut is just for saving weight.You see how the point is rounded off at the bottom of ring gear the tooth? The first listing is a PRO gear set. I'm thinking you dont need a PRO set. That Pro set looks pretty rough anyway.|
|This thread has more than 15 replies. Click here to review the whole thread.|