|06-25-2003 11:31 PM|
|ChrisMiddleron||DAmn.. Hah that was easier then I thought. Removing some bolts, and the greasy round thing that the window attached to some force and it came out. Took about 10 mins|
|06-24-2003 11:32 PM|
|outlaw17||ChrisMiddleron , you need to take the door panel off then just look at how the glass is attached to the regulator , some are bolted and you just unbolt them tip the glass to get it out of the channels and then lift out the top , and then some get tricky but just look close at how it operates , roll it down and up a few times watching what its doing and you should be able to figure it out .|
|06-24-2003 07:18 PM|
I replaced the passenger side window in my 57 truck, and even with the shop manual it proved to be a somewhat difficult task.
I don't know about anyone else, but I actually had to stick a screwdriver in the opening of the door where the window pops out, and PRY just a tad to get the vent window in and out.
|06-24-2003 06:25 PM|
I just replaced all the felt on my 54 Chevy pickup ... had to remove the windows from the doors ... the only way I could do that was to remove the entire vent window assembly -- not too difficult, though.
You can see pics at my site (link below my sig).
Hope that helps.
54 Chevy Pickup
|06-24-2003 03:45 PM|
|ChrisMiddleron||Yea i need some help with mine mine are all cruddy and greasy at the bottom I gotta give them a cleaning but I dont know if I have to remove the whole inside door to remove the window, or just a few bolts|
|06-24-2003 11:54 AM|
I'm having trouble figuring how to get the driver's window out of 1950 chevy 4dr sedan. I have a shop manual that tells me exactly how to do it but the glass seems to be bigger than the orifice that it is supposed to come out of. It seems like i forgot to take something out to make the hole bigger but i can't see it. If anyone has any tips please speak now or forever hold your peace.
|06-23-2003 04:49 PM|
Remove windows inside of doors Help!
Hey yall I have a 1972 ford pinto that I am getting ready to paint. Im going to replace the windows with cardboard, and give the windows a very good cleaning and tint them. But the thing is I dont know how to. Can anyone that has done this before tell me how? Thanks, Chris