Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Interior> vinyl question
User Name
Password
lost password?   |   register now

Thread: vinyl question Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-15-2010 10:48 AM
DanTwoLakes 99% of all vinyls only stretch in one direction, what is called two-way stretch. It may be laid out on the roll so that it stretches from top to bottom on the roll or from side to side on the roll, but it still only stretches in one direction. The vinyls that stretch in two directions ( four way stretch) are very limited in color and grain and are intended for things like ATV seats, jet ski seats, etc. Car seats have been made with two way stretch vinyl forever. If your seats are not turning out correctly, there is something else wrong that has nothing to do with the vinyl. Most upholsterers will tell you that too much stretch, and especially in all directions, is as bad or worse than not enough stretch.
04-15-2010 08:08 AM
red65mustang one way stretch=more backing threads in one direction versus the other is why...

my $.02:
if you haven't started yet,,,see if you can exchange the material for a bi-axial stretch (same threads count both directions) material...

I'm just a novice but after doing my car I can tell you "no way" could I have done it to turn out great looking with one way stretch material (except maybe the flat door panels)....
04-15-2010 07:30 AM
DanTwoLakes You are right, in general all you have to do is keep the stretch in the same position on all the pieces. My choice is to have the vinyl stretch side to side on car seats. The reason being, it's a lot easier to cut something down if it stretches a little too much than to do it over because the vinyl won't stretch. On anything else, like a door panel, it doesn't much matter.
04-14-2010 06:45 PM
chman
vinyl question

Hi,

I'm doing my first upholstery project (a 1966 Chevelle) and have a simple question. The black vinyl I'm using to make the seat covers only stretches in one direction, so I guess I need to be consistent when using it.
Should I orient it so it is always stretching top-bottom or left-right? This is the vinyl I'm using ... in case it matters.

Thanks for the 'newbie' help!!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:45 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.