Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Garage - Tools> Cambell Compressor Specs
User Name
Password
lost password?   |   register now

Thread: Cambell Compressor Specs Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-20-2010 11:01 AM
oldred You need to look at what really matters and whether it's 60 gallon or 80 gallons don't mean squat and will make no difference in performance THERE IS NO DISCERNIBLE DIFFERENCE in performance between a 60 gallon tank and an 80 gallon, all other things being the same! What you need to consider is the compressor type and motor, in this case that is just a simple single stage pump of a very common model sold on home type compressors. The motor will be a 240 volt, most likely a Century or possibly an Emerson either of which is so-so quality. The point is don't pay much for this thing because it can be bought for as little as $400 new if it is the 3 1/2 HP 15 AMP version (usually mounted on a 60 gallon tank), that 3 1/2 HP can be listed as high as 6 to 7 HP "Peak" but if the motor is 15 AMPs the HP is about 3 1/2 and the "Peak" rating is just sales gimmick non-sense. These little single stage pumps have a comparatively short service life to a good two stage so if it has a lot of time on it then it may have reduced performance. Open the drain valve and check for rust colored water which would indicate internal tank rusting, if it rusts through and starts leaking it is scrap and CAN NOT be repaired! Check for excessive oil around the pump crankcase vent which would indicate pump wear and blow-by which are common ailments of a high time pump. Regardless of what kind of specs you find published by the manufacturer about the best you can expect from that little single stage pump is going to be about 10 to 11 CFM@90 PSI for the 15 AMP version and no more than 13 CFM for the larger versions, that's if and only if it is like new because these figures decline as pump time increases. Once again, look at what counts and DON'T be swayed by the size of the stinkin tank it simply will not make the thing perform any better in spite of the common myth!



BTW, since "Peak" HP has been discussed so much here in the past I thought it might be of interest that CH has recently started rating that 15 AMP motor at a much more realistic 3.2 HP instead of the BS 6 1/2 HP number!
04-20-2010 08:49 AM
302 Z28 Get all the information from the nameplate and get online and do some research on it.

Vince
04-20-2010 04:14 AM
wayneooo it looks pretty nice if it works good and the price is good buy it looks like 80gal
04-19-2010 08:57 PM
Boostin1989
Cambell Compressor Specs

I might be able to get a Campbell Hausfeld VT5587 (or VT558704) compressor. It's an upright 60 or 80 gallon deal. Anyone have any specs on these? I couldn't find a manual or anything on it. Anyone know what this would be worth? Here's the best pick I have:


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:21 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.