Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Locking Mech and vac advance on HEI issues
User Name
Password
lost password?   |   register now

Thread: Locking Mech and vac advance on HEI issues Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-20-2010 06:46 PM
speedfreak2 If you really want to lock out your HEI by welding it then simply remove the weights and springs and weld it. One of the reasons that your timing retards as RPM increases is the fact that there is a certain amount of "Dwell" built into the module hence the reason for centrifugal advance. You really should toss the module along with the weights anyways and get yourself an aftermarket ignition box and fire it off of the magnetic pickup.
After you weld the distributor you should make sure it is phased correctly. Pay someone to put it on a distributor machine. It can also be done in the car but it takes patience.
05-20-2010 11:59 AM
BBCMudbogger I just had to...seems like I'm more smart *** than helpful these days....weld it better?....just yankin yore chain man
05-20-2010 11:23 AM
maxpower_454 Ok so the tack welds broke on the weights. How else can I lock my mechanical advance?
04-26-2010 12:20 PM
cobalt327 Excessive end play on the distributor shaft will cause at least some of it. You want to set the play to ~ 0.017"-0.020". I've seen them over 0.100".

Mr Gasket and others have shims for the HEI. The shaft is ~0.490" OD.

What you're probably seeing is a combination of the timing set, distributor end play AND the cam being forced rearward.
04-26-2010 11:24 AM
red406 Could it be the cam walking in or out?
04-26-2010 07:12 AM
maxpower_454
Locking Mech and vac advance on HEI issues

I got a plate to lock my vac advance. I took off the springs and rotated the weights and plate to full advance and tack welded it. Now for some reason when I rev the engine the timing will retard about 4 degrees. Anyone know why it would do this?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 01:26 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.