Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> engine combo...thoughts?
User Name
Password
lost password?   |   register now

Thread: engine combo...thoughts? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-12-2003 02:57 PM
redcamaro4spd sorry, but need to bump for weekend crowd
07-11-2003 10:28 PM
redcamaro4spd Super t10 coupled withan open 3.73 rear (currently 2.73, but will be switched soon)
07-11-2003 10:15 PM
akm trans?
07-11-2003 10:00 PM
redcamaro4spd
engine combo...thoughts?

okay, so I know yo are all getting tired of me asking about the 350 I am building. So I thought I would post my specs at this point and see what you all had to say. Hopefully, soon I won't be needing advice setting it up as it will be dropped into the car. Okay, here goes:

1986 350 (4 bolt main)
Bored .030 over
Summit Engine Rebuild Kit with:
-Sterliong Pro pistons at .275 inch dome to produce 10.26 to 1 comp.
-high volume oil pump
-fed. mogul bearings
-fel pro gaskets

Other specs:
462624 heads with 1.94/1.50 valves and 76cc chambers
Comp Cams 268XE with .477/.480 lift (cam and lifter kit)
Edelbrock Performer Intake
Edelbrock 600cfm Carb
Dynomax headers into 2.5" dual exhaust
Stock crack, rods, rockers, HEI dist., and accessories

I think thats it, if I forgot something lemme know and I'll post specs. I hope to run on 93 octane pump gas. Please let me know what you think. BTW I know my heads are cruddy, but they'll have to do for now...Thanks again folks...

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 01:43 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.