|05-04-2010 02:20 PM|
Yes it has the foam backing, i will buy better scissors for next time. I will try the puddy knife and see if it helps the look.
|05-04-2010 01:52 PM|
I assume you used the stuff that already had the foam bonded to it. I cut it with a good scissors.
Are you talking about trimming it after it's up on the roof? If so, you need to leave it a little long and then push it down into the rubber seal. I use a heavy putty knife with the corners ground off to do that. That will leave you with a nice clean edge.
|05-04-2010 11:56 AM|
98 Nissan headliner redone
Heres the headliner i did for my friend. It was really bad had a bunch of tacks holding it up.....looked like stars....lol
I do have a question about cutting headliners material. What do you use to cut it i used a razor blade but it didnt cut it good. After i finished i thought about a electric knife might have been better.
Heres the pics
as you can see on the last pic