|03-16-2014 04:25 AM|
|64SS327||Nice work so far. She should be a fun one to drive.|
|01-12-2014 07:34 PM|
|77bronco_ed||Test fit passenger pan before adding beads...|
|01-05-2014 04:33 PM|
I had asked if it could be done early in the thread… However it did not sound like it was possible.
|01-05-2014 04:31 PM|
|Crosley||Since this has become a Project build on the Bronco, I am moving it to the Project forum.|
|01-05-2014 04:27 PM|
|01-04-2014 07:38 PM|
|77bronco_ed||I just need to make the front passenger side floor pan and I can move to the firewall.|
|12-08-2013 06:06 PM|
Yes... I know how that goes. The red Bronco in my profile was started when my first daughter was born. Priorities changed, she was starting college before I finally got to use it. (It is all glass) I tried to sell a few times but chickened out. I have been using it for about 5 years now. Now that I am older... Well I want to cruise a little and hang out Kids should not slow things down now.
I raked the window at the rear of door for a sleeker look. This rusty truck was in a fire before I picked up (fire damage sale
|12-07-2013 06:12 AM|
|big gear head||Going to be sharp when you get done. Don't give up on it. I spent 18 years getting my Camaro on the road. I hope it doesn't take 18 to get my Chevelle going.|
|12-06-2013 09:45 PM|
|77bronco_ed||A couple more...Tossed in a pic of the drivers side floor I fabbed up. (hammered in the beads to add a little strength) The tunnel was shifted to give driver and passenger side equal space.|
|12-06-2013 09:12 PM|
I have most of the front floor done...(Lowered) I need to get some space back in the garage so I set the body over the frame. I was getting a little excited so I skipped around to give the top a try to keep up the motivation.
Passenger side tacked up, driver side started.
|07-05-2012 05:21 PM|
|77bronco_ed||Engine and trans nested for placement.|
|07-05-2012 07:21 AM|
|77bronco_ed||In seeing how my build was progressing not much of the original frame was left. I ended up going in a different direction... I had a small company "checkered racing" build me a frame. The price was very good and I have a much cleaner build. I was getting into areas that I did not have much experience in and thought it is best to make sure that it will drive fine once finished. Some modifications were still needed to the frame but... All in all it is coming along.|
|07-29-2011 10:00 PM|
As I understand it , even Jon can not move this thread to the journals
|07-29-2011 09:43 PM|
|NEW INTERIORS||Very nice... I like it ...|
|07-29-2011 08:34 PM|
Picked up an engine and tranmission for my build today!
Only has 11,000 miles. I want to build the internals a bit more Pistons, rods, but since it is practically new I'll get it in get it running and use it a while. Beef it up at a later time, eventually I will add a supercharger.
|This thread has more than 15 replies. Click here to review the whole thread.|