|08-07-2010 11:21 AM|
If its a dohc pent roof chamber then you could probably run 87 octane as a lot of oem's recomend that.
Need more details.
|08-07-2010 07:58 AM|
depends what engine and heads and load. what engine are you talking about? What car? do you plan to pull a trailer? what gear and trans?
If it is a 454 with stock iron heads then I would say no.
if it is a 350 with flat tops and vortec iron or aluminum heads then I would say, no problem with 93 octane.
If it is a 1100cc honda then it would be ok too.
some of things that effect octane requirement are flame speed, piston diameter, head material, head chamber design, and others.......
10.3:1 cr with 195psi of cranking pressure means the cam is fairly mild.
would require 93 octane in most cases.
|08-07-2010 06:23 AM|
195 PSI 10.3 to 1 compression on street fuel
Hey! what are your thoughts on running a motor on pump super with 195 psi compression and 10.3 to 1 ratio?