Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Is my compressor too small?
User Name
Password
lost password?   |   register now

Thread: Is my compressor too small? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-22-2003 02:52 PM
willys36@aol.com
Quote:
Originally posted by asennad
If I re-wire it for 220V will that help?
Nope. Will put out the same HP. May be easier on the motor by drawing fewer amps @ higher voltage => a little less heat generation.
07-22-2003 01:16 PM
asennad If I re-wire it for 220V will that help?
07-22-2003 02:26 AM
4 Jaw Chuck ...unless you use a very fine pencil tip on your blaster and switch to soda media. The soda is super fine and works well with tiny orifice holes, leave the sand for the bigger guns. Soda does a very nice job on rust since it penetrates deeper into the pits and is gentler on the material, burning through is nearly impossible with soda.

Give it a try and see if your compressor can keep up at 90 psi with a fine tip.

Little tip, the Arm and Hammer soda at the grocery store is the same thing you get bulk.
07-21-2003 10:36 PM
willys36@aol.com 5 hp, 2-stage compressor (120 psi rating) with 60 gallon tank is the bare minimum for satisfactory results in what you are doing.
07-21-2003 09:49 PM
asennad
Is my compressor too small?

I bought a compressor several years ago. It is a DeVilbliss 4.0 30 Gallon. It puts out 6.9 CFPM @ 90 PSI. t. I bought it mostly for sandblasting and painting. However I have never been happy with the results of sandblasting. I have used glass bead and some black oxide something but I find it still doesn’t completely remove all traces of rust. Is it too small? What can I do to make it better? Should I try different abrasives?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.