Hey everyone, I am going to trying to put a roller Crane cam out of a 1985 LT1 350 Chevy into a 1993 ZZ3 roller motor. I have been told that Crane cam part #119641 will not use the cam plate to hold it back and that I would need to use a pre 1988 cam gear and a Cam button.
Any thoughts will help.
Yes, you can put an "old style" roller cam in a factory roller block by using a cam button just like you would in a pre-roller and then you can use the factory roller lifters but there was no LT-1 in '85. The early style LT-1 was '70-'72 only and there are those that would argue that '71-'72 don't really count because of the lower compression.
Flattery will get you everywhere. I only wish I was correct as often as I think I am.
Yes, you will need the early style timing set.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Hot Rod Forum
2.2M posts
175.7K members
Since 2001
A forum community dedicated to hot rod owners and enthusiasts. Come join the discussion about restoration, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!