Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Interior> What is a good way to do french seams?
User Name
Password
lost password?   |   register now

Thread: What is a good way to do french seams? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-16-2010 10:45 AM
ronbo Thanks Dan, I'll try it!!
09-15-2010 08:52 PM
DanTwoLakes Yes, you can sew the seams first and then glue that whole assembly to sew foam. I glue the foam pieces together with butt joints to keep from wasting large sections of sew foam. From that point, you can then trace the pattern onto your fabric and sew around the edges. Take a look at post # 27 in this thread: CLICK HERE
09-15-2010 04:04 PM
ronbo
What is a good way to do french seams?

Planning on doing some french seams on my seats. I've sewn a sample in vinyl using 1/2" sew foam and contact cement and sewn around the perimeter of the piece. The first or main seam was fine. Then I tried sewing the outside seams with ?bias tape. My sewing was finished side up. The ?bias tape? was a mess, very difficult to keep straight. The outsides were fairly wriggly due to the bunching, bias tape and bulk of the sew foam.
I'm wondering if I could sew the seams first and then add the sew foam afterwards. I would then contact cement the foam and sew foam to the vinyl together. Is there a better plan? What is the best way?
Thanks for your help.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 08:43 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.