Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Pulley Thead bad looking for Tap. bolt 09440024
User Name
Password
lost password?   |   register now

Thread: Pulley Thead bad looking for Tap. bolt 09440024 Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-06-2010 03:53 PM
ericnova72 You are correct, 1.27mm per thread
10-06-2010 03:28 PM
monette999 Hello Eric if I go after the ANSI table I have 20 threads per inch.

1 inch is 25.4mm. If I devide 25.4mm/ 20thread I get the slope 1.27mm per thread. Am I correct.
That 2.25 in is the lenght.
Than should be this the correct thread.

Thanks for your help.

7/16" - 20 UNF 0,438 11,112 9,90 20 1,270
10-06-2010 01:42 PM
ericnova72 7/16" - 20 is UNF(fine), 7/16"-14 is UNC(course)

Tap you need is 7/16 -20 UNF.

7/16" is bolt diameter(=.437"), 20 is threads per inch, UNF is Unified National Fine.

UNC is Unified National Course.

2.25 is the length of the bolt in inches, not the slope. You've been playing with metrics too much, haven't you
10-06-2010 01:00 PM
monette999
Pulley Threads bad, looking for Tap, bolt 09440024

Dear all, on the GM catalog it is a 7/16 - 20x2.25 300M POR

0.437" diameter
20 threats
is 2.25 the slope.

What tap do I need UNC or UNF

Most taps to buy are listed 7/16 20.
How do I pick the correct one?

BOLT, (7/16-20X2 1/4)

BR Mo

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:42 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.