Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Electrical> Wiring windshield wipers to toggle switch help
User Name
Password
lost password?   |   register now

Thread: Wiring windshield wipers to toggle switch help Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-30-2010 12:48 AM
1971BB427 Some wiper motors are wired with a hot wire to the motor, and the switch grounds one or the other terminal to ground it and make it operate. Not sure if the Jeep is this type of a setup?
12-29-2010 04:46 PM
vicrod The wire colors you provided don't check out with any available diagrams.
But this may help.
Referring to the posted diagram;
A black wire is indicated. This is ground. It may be the motor housing or a separate black wire.
The red/yellow wire is high speed.
The Brn/white wire is low speed.
The remaining wires and symbols are the park switch etc. that won't be used.
You only need to connect the wires leading to the motor.
Using a single pole, double throw, center off toggle switch connect the center (common) terminal of the switch to 12 volt + fused.
Connect the red/yellow wire to one of the remaining terminals.
Connect the brn/white wire to the other terminal.

vicrod
12-28-2010 09:50 PM
crownver Here's a wiring diagram, but not sure if it's going to help wire the wipers to a toggle switch.
12-28-2010 06:34 PM
fschevy
Wiring windshield wipers to toggle switch help

I have a far from being a hot rod 93 jeep cherokee that i use for a play rig. I couldnt find help anywhere else hope to find it here. My wiper motor has 4 wires coming out of it. Red, brown, black with green stripe and green with black stripe. Wanting to know how to wire these to a simple toggle switch, or what kindve switch to use so i can have a high and a low maybe. A wiring diagram or any help would be appriciated thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:09 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.