|Today 12:21 AM|
I'm going to say it a 1960 Chrysler 300 F
'59 had a completely different dash; and while the '61 had the same dash, it didn't have the pleated upholstery we see here
|Yesterday 10:06 PM|
I'm going to say 1961.
Does that vehicle have add on A/C? About the same time as that vehicle was new Climatic(?) air was making a unit that used the defroster duct as air outlets. They replaced the outlet grills with a rotating outlet vent.that looked just like the ones sitting on top of the dash. Looked great, worked mediocre.
|Yesterday 09:11 PM|
|CrashFarmer2||1960 Chrysler 300|
|Yesterday 09:11 PM|
|496CHEVY3100||I think it is a 60,,the 58 & 59 had oval square sterring wheels and the 61 had a ribbon type speedometer Probably a 300 letter car|
|Yesterday 08:11 PM|
It is one of the coolest dashes I've ever seen. What's even cooler is the instruments are electroluminescent - they light up like neon.
|Yesterday 04:40 PM|
1958 300? Damn I love that dash and wheel, the speedo is WILD, that era was so cool!
|Yesterday 04:12 PM|
Wow that was a lucky guess on my part.
What year and model is this Chrysler?
|12-09-2013 06:42 PM|
|BruceKoukalaka||You got it JoeG although Dave57210 was close in a PM. In the Austin Somersets the jack is set through the floor beside the driver's or passenger seat and requires a BSW nut driver and there is no room to put a spanner wrench there. The lugnuts are 11/16" but the jack is very odd sized. It is 1/2 BSW.|
|12-09-2013 06:29 PM|
Did this tool come with the car?
|12-09-2013 06:20 PM|
To remove hood so you can find the electrical short..lol
I think it might be a manual start handle.
|12-09-2013 05:45 PM|
|Joe G||Jack handle|
|12-09-2013 01:59 PM|
Ok so here's the tool, it has a specific job for a British car,
|12-09-2013 01:09 PM|
|BruceKoukalaka||Sorruy about the time delay in getting the picture up, I'll have it this afternoon as I have to dig the car out to get to it .|
|12-07-2013 03:13 AM|
|BruceKoukalaka||The only reason I know about the bead hammers is I use them still. however the rim hammers that I used in the past are very similarly designed. I'll do a picture of a tool tomorrow as I can't get to it tonight.|
|12-06-2013 02:13 PM|
OK Bruce give us a good one!
|This thread has more than 15 replies. Click here to review the whole thread.|