Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> need a drip rail for 1931 Graham are Fords the same ?
User Name
lost password?   |   register now

Thread: need a drip rail for 1931 Graham are Fords the same ? Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-05-2011 10:10 AM
1931 Graham drip rail

I think he is still out there. I had to replace my right side of my 40 ford coupe, rust near the decklid missing 7 inches. I just replace all of that side. It was in the rain on pole barn side, the other was fine.
I got inside and carefully with a circle cutoff/hammer and chisle without distorting the outside. You only need just that the drip rail can slide from outside. I have never seen a 31 Graham. Gene's would probably would start with a machine with a straight drip rail. I would think your model would be better that way. Maybe just take the top off for you project, when you could easy if you understood. If it is more like a forty ford. If you send me a photo of your Graham. Grahams are really neat, if it is like a box, all you have to heat the cut/pie/corners. Use alot of clamps, clean joints or sandblast inside and use Epoxy after tacking with a mig welder. If you have curves on the rails, you will have to heat as matching with the seams. That's how I did it on my forty ford.

Good luck!
03-30-2011 07:13 AM
1931 graham rod
need a drip rail for 1931 Graham are Fords the same ?

Hello Everyone,
I am looking for a drip rail that goes on the right side of my 1931 Graham Prosperity 6 it is 5 ft. 6 in. long and has about a 3 in. bow to it. It comes in 2 peices you nail the first peice on and i beleive snap the rail on after. So i was wondering if Model A Fords had the same supplier years ago and would know where i can find this drip rail. PLEASE HELP !!!!!!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 04:25 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.