|04-20-2011 01:35 PM|
|DanTwoLakes||No need to apologize, you didn't do anything wrong. You didn't post your phone number or your e-mail address, I just wanted to keep you on the right side of the law!|
|04-20-2011 12:25 PM|
My apologies. I realized after you posted that it looked like I was trying to advertize in this domain. That was not my intent. I appreciate your response to my question.
|04-20-2011 09:57 AM|
List your seats in the classified section when you are ready to sell them, you can't advertise in the tech forums.
Bench seats out of Chrysler minivans are used by a lot of the guys with '32s. Check out this thread: CLICK HERE As with any seat that's going in a vehicle it didn't come out of, you need to get it the right height off the floor, so you'll have to come up with your own mounting brackets based on your individual car. Your brackets will then be bolted to the stock seat adjusters already on the seat.
|04-20-2011 09:47 AM|
Replacement bench seat for 32 3wdw
Maybe someone can help me here. I currently have bucket seats in the 32 and they are to wide for the car. I read somewhere that there is a bench seat out of a small pickup that fits into the 32 with only a modification to the mounts. Is that correct and if so, what model pickup seat works. Thanks for any help.
By the way, once I am able to determine if this is possible I will have two sets of buckets for sale. One set out of a Dodge Daytona (80's, driver's has power) and another set out of a Fiero.