Hot Rod Forum banner

Drag race Wing For S10 Pickup

12K views 3 replies 3 participants last post by  HotRodS10 
#1 ·
Need some input on building or buying a wing for a 1991 S10 Picup Drag truck
 
#3 ·
B-D, I dont know a whole lot about spoilers but I have noticed most of the S10's at the track, at least around here, use an aluminum bed cover that extends about 12 inches past the tailgate. There is a plate welded on each side from the rear corners of the cover down to the bottom of the tail lights. You may not be getting a mental image of what I'm talking about so I'll look around on the net and see if I can find a pic of one of these. I dont know if it works or not but I have seen at least 4 different trucks with this same design. I hope this helps.

Later,
HRS10 :cool:
 
#4 ·
Here is a page that shows a few images like I was talking about....when you get there click on pro stock truck and it will give you a list of names...most of them are running S10's. Craig Eaton has the best looking in my opinion.

<a href="http://www.nhra.com/images/gallery.htm" target="_blank">http://www.nhra.com/images/gallery.htm</a>
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top