Hot Rod Forum banner

Please point me in the right direction??

1K views 6 replies 5 participants last post by  tech69 
#1 ·
I was just hoping someone can point me in the right direction of metal forming tools. Ive done HVAC for 2 years so I have a BASIC understanding of sheet metal. But nowhere near what I would like to know.
This is all going to be a learning process so I just want to buy some tools that will help me begin and go from there.
What should I buy 1st 2cn 3rd etc.?
Thank you very much!
 
#3 ·
You will need a stump and some hammers, a tucking fork, sand bag and a thick piece of steel for a hammering table about a foot square. some shears that you own and go from there..the tools required are real simple.

And get a couple of books on the subject and do not be intimidated by the guys who say you need a bunch of fancy metal forming tools to do anything..

Sam
 
#4 ·
tin knocking.

I took a class from Ron Covell, I was amazed that he took a sheet of aluminum and a sand bag and started beating on it. It had a bunch of lumps, he then worked it on his english wheel to smooth it out to get the compound curve. I had always tried to gradually work to the shape I needed. an old soft leather purse filled with sand works almost as good as an expensive beating bag filled with buckshot. Check out Cboys build threads here on this site, He has a lot of good how he did his cars I took a panel fab class at UVU. Check out one of the students build. google "chris davenport 40 willys "
 
#5 ·
I agree with what Sam is saying. Buying a bunch of fancy stuff before trying it can be a waste of money. Get the basics and learn metal with basic hand tools.

I'd also add:

shrinking disk (requires buffer)

tear drop mallets( I got a good one from harbor freight and shaved the head nearly flat. The best hammer I have. I have both sized they offer)

palm nailer (make your own bits)

ear muffs

a slapper. I don't have one but use a dinging spoon. Will probably get a slapper soon though. Hear a lot of things about them.

Here's a pic of some 1947 fenders after one round with a palm nailer on shot bag and then shrinking with a disc. At this time I was still figuring out the best procedure but was amazed with how good it got with one round. I guess it's easy for me to sit here and say "it could have been perfect had I repeated the process" but I don't know that but I did feel if I repeated it would have made a huge difference. Just not sure how close to perfect I could have gotten due to time but it's a start in that direction.

 
#7 ·
I'd like to ad shop vise too. A brake would be nice but I just used a vise at first. I actually made pieces for this in a vise. If you look closely it has a compound curve. Not sure if that would be possible in a brake. As you can see I did it in sections so the compound curve would be possible. Obviously the next section would be the rust you see on the right.


 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top