Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> Honda Civic Pressure Plate Symptoms?
User Name
Password
lost password?   |   register now

Thread: Honda Civic Pressure Plate Symptoms? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-27-2011 05:59 AM
jcclark
Quote:
Originally Posted by willowbilly3
Did you have the flywheel resurfaced? Did you use a crankshaft shim? .
No, I just installed a clutch kit while I had the engine out.
What and how should I check things if I tear it down again?
05-27-2011 05:57 AM
jcclark
Quote:
Originally Posted by Gringo
Did you get all the air bleed from slave cyl ?
Yes, I know to bleed those things a lot, they are notorious
for leaving a air bubble since the lines run uphill on the firewall.
05-27-2011 03:58 AM
willowbilly3 I'm not familiar with those cars but you might also check the firewall where the m/c mounts. If it is stressing or flexing a little you would be loosing stroke. I have seen it on other makes.
Did you have the flywheel resurfaced? Did you use a crankshaft shim? Since the days of adjustable clutch linkage are long gone, that stuff becomes pretty critical. If it was assembled on the ragged edge of being out of specs, then a small amount of wear would put it over the edge so to speak.
05-26-2011 01:56 PM
Gringo Did you get all the air bleed from slave cyl ?
05-26-2011 10:29 AM
jcclark
Honda Civic Pressure Plate Symptoms?

I have a front wheel drive Civic that I put a new clutch and pressure
plate in 40K ago. For the last couple of months it has been getting
harder to shift. I also have to be going slower to downshift then I used
to be. I believe the clutch plate is still good, I replaced the
master cylinder and slave cylinder.
When I stop in reverse, it's really hard to shift to 1st, unless still rolling.
Could this be a pressure plate problem?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 09:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.