|07-12-2011 05:34 PM|
|07-12-2011 10:05 AM|
|BOBCRMAN@aol.com||Be aware that there are also several different 454 flexplates. So be careful to match the years. Later flex plates are more weight. ALL WILL BOLT UP TO A TWO PIECE OR ONE PIECE SEAL CRANK.|
|07-12-2011 08:56 AM|
my bad, it's a flexplate, automatic transmission.
it doesn't have any weigths, it's a regular 350 unit for sure.
but the engine is not damaged, maybe I stopped it just in time...
|07-12-2011 01:22 AM|
Far as I know they`re external balance on a 454.
If a non external balanced job was installed it wouldn`t have ran very
long before it destroyed the thrust surface. One time when I happened
to be in the same place where a guy swapped on a new flexplate on
His 400 small block that was a 350 unit, he got out of the driveway and
about 60 yards away before it started knocking.
In this case do you mean flywheel as in for a stick shift or flexplate for a automatic?
|07-11-2011 09:27 PM|
OOOOPS...!!! 454 flywheel.. wrong part???
454 flywheels do have balancing weights on them right?
I just discovered that my engine is running with a regular non balanced 350 flywheel, but I haven't noticed any strange vibrations.
my engine comes from a 1984 C30 pickup, did this engine come from the factory with a balanced flywheel? are all 454's externally balanced?
the previous owner must have changed it and didn't noticed the difference.
I'm doing a cam swap and some minor porting before it goes into the engine bay of a '46 chevy, will bolt to a modified TH350 with a 2.200rpm converter and 4.11 rear end.