Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> Speedometer Cable Bolt
User Name
Password
lost password?   |   register now

Thread: Speedometer Cable Bolt Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-17-2011 06:49 AM
SSedan64 You don't need the Speedo Cable connected but, you do need the Speedo driven gear & Bullet/Housing as Crosley said above.
10-16-2011 08:25 PM
2000jack That intersting, i will keep an eve for an old cable to put back in sometime
10-16-2011 07:46 PM
Crosley Some of these retaining bolt holes use a 1/4 x 20 bolt, some are metric with 6mm x 1.0 thread.

the speed-O gear does more than spin the cable. It also splashes oil onto the bushing for the drive shaft yoke.
10-16-2011 07:44 PM
Cape Cod Bob The only stupid question is the one not asked. It could be the threads in the hole need to be chased or the bolt you tried is bunged up. I would try a different bolt. Mine takes a 1/4 x 20. It may well be a metric so get some various sizes at the hardware store and try em.
10-16-2011 10:23 AM
2000jack
Speedometer Cable Bolt

I got my roadster going and ran into a lot of leaks the newest is the old speedometer cable which had been cut off fell out of the TH350 transmission case. I am going without a speedometer as I will use my TomTom system instead. Anyway the bolt that held the old speedometer cable in place is now missing. I want to build block off plate and hold it in with this bolt. It seems to be metric. Does anyone know what size it is or do I go to the hardware store and buy 3/4 size and thread count? I tried a 1/4 course and it seemed to stop after one turn. This might sound like a stupid thread but I don't want to screw up the housing by bolting the wrong one in.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 04:40 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.