Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> Can I transfer the Yoke from my PG to a 200 4R?
User Name
Password
lost password?   |   register now

Thread: Can I transfer the Yoke from my PG to a 200 4R? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-07-2011 03:23 PM
B@D Yes just barley I usually tell people if they are doing a conversion insert the yoke all the way into trans then pull it out about 1-1.5 inches , that is where you want it to give it clearance to travel in and out as the rear moves up and down .
11-07-2011 02:03 PM
mrpate The 27 spline yoke from the power glide seems to work.

On the power glide transmission the spline was inserted 2.75 inches into the yoke. Is this depth also acceptable for the 200 4R?

The small block chevy that is coupled to the 200 4R will produce approximately 350 h.p.

Thanks for your responses------Mark
11-04-2011 03:50 PM
B@D A 1967 glide should be a 27 spline , all 2004r is a 27 spline so it should work fine
11-03-2011 02:10 PM
mrpate
Can I transfer the Yoke from my PG to a 200 4R?

I am replacing the power glide transmission in my 67 vette with a 200 4R. The 200 4R does not have a yoke on the transmission. Can I remove the yoke from my power glide transmission and install on the 200 4R? It appears that both are 27 spline, but I do not know if the shaft that extends from the yoke is the proper length in order to fully seat into the 200 4R.

If the yoke will work on the 200 4R, what is the best way to remove it from the power glide.

Thanks----Mark

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:48 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.