Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Ignition problem???
User Name
lost password?   |   register now

Thread: Ignition problem??? Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-29-2002 05:53 AM
FASTFORD i agree with Tom.i run a unilite also.i had 1 problem and had to replace the module inside the distributor.usually,when the module goes bad,it does not work at all. i strongly urge you install the power filter to avoid ruining the module. let us know what fixes your problem,good luck.
06-28-2002 06:41 PM
Tom try a different coil,sometimes a coil will go out after it's run awhile,then start again after it cools.I have run the unilite a few times and found no problems. what you have described to me sounds like the coil
06-28-2002 04:51 PM
Ignition problem???

I have a problem with hard/no starting after the engine has been run for about 30 minutes and has come up to temperature. This motor doesn't run hot and stays around 180-185 degrees even on hot days.

I originally thought it was a vapor lock problem but I checked the carbs (dual Carter AFB's) and they are spraying fuel. Then I hooked up a timing light and cranked the motor. There was no spark so obviously it's an ignition problem. I'm just not sure if it's the coil or distributor. Iím running a Mallory Unilite vacuum advance distributor and a normal high performance conventional coil.

Has anyone ever had the electronic module in a Unilight refuse to work when hot? I'm thinking that's the real problem and since I don't race this big block and it never sees 5 grand on the tack, I'm thinking of switching to a dual point setup that won't be bothered by the heat.

Any suggestions?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 09:59 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.