Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> super t10h gear ratio change
User Name
Password
lost password?   |   register now

Thread: super t10h gear ratio change Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-19-2011 02:38 PM
AutoGear Whats your axle ratio?
12-19-2011 09:55 AM
cobalt327 One cure for too tall (high) first through third gear is a shorter (lower) rear gear. But obviously that carries on to high gear. If a different trans isn't possible, you might look into a Gear Vendors OD/UD unit. They ain't cheap.
12-19-2011 09:31 AM
AutoGear According to my boss, you have 2 choices in the ford for 1st gear. Your current 2.78 1st and a 2.32(?) 1st. 2.32 would require an axle something like a 3.73 or higher (preferably a 4.11)
12-18-2011 12:47 PM
BOBCRMAN@aol.com Usually the input and cluster..
12-18-2011 02:02 AM
pcarbuckle
super t10h gear ratio change

i have a borg warner super t10 h
The tag on box has hek ao 1
The casting on main box has t10h 1wg div w 1b 23
The casting on tailshaft has t10h 7b wg div a
It has a 27 spline output shaft
The problem i have is that it is to tall in 1st 2nd and 3rd
What gears do i need to lower the whole set up

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 12:25 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.