Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> 78 camaro/700r4/driver shaft
User Name
Password
lost password?   |   register now

Thread: 78 camaro/700r4/driver shaft Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-22-2011 07:50 PM
adantessr I just had a driveshaft retubed and balanced and one new u-joint put in for less than $100.oo .
12-22-2011 07:10 PM
dogwater Well what I really want to do is use a drive shaft from a donor car something that is stronger than whats in it now.I'm not sure if the original drive shaft will hold up. When the 78 Camaro came off the show room floor it only had about 190 HP,and not real light either 3800 lbs.So I think this drive shaft (original) my not be strong enough.I'm out of cash, threw it all at the 700r4,so its use what I have or find a straight one in the bone yard.I can cut it and weld it just need to get it balanced.Anyone out their do this? One more thing carbon fiber drive shafts,I'm forever stepping over them, are then good for anything,can they be shortened? I don't know much about them.
12-22-2011 01:13 PM
SSedan64 You wont find a DS the correct length at a Yard. Just have yours Shortened & Balanced and new U-Joints installed where the Zerk fitting is under compression load or the correct way. You wont need super duper fittingless U-joints at your power level.
The DS Shop will tell you how they need you to measure for length.
12-22-2011 07:34 AM
dogwater
78 camaro/700r4/driver shaft

I'm getting ready to install a 700r4 into my 78 Camaro,but I need some drive shaft answers. It has th350 in it now.Can the drive shaft that's in there now handle 400 HP.I need to shorten it 3" for the 700r4.Or should I go to the local pick&pull an find a good one their? What would be a good donor car to look for,I was thinking something like a big station wagon or truck that might of had a 700 in it before.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 04:13 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.