Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> muncie stuck in reverse
User Name
Password
lost password?   |   register now

Thread: muncie stuck in reverse Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-26-2011 06:50 PM
OMARS67 Messed with the tranny today and notice that the shift nob had came a little loose tighten it down and bingo !!!! Problem solve thanks fellas
12-24-2011 10:03 PM
tjet If the shifter is in netural, the linkage arms should be in netural. It's easy to see once you pop the rod off.

The prob I had was that pilot brg ID was tight on the input shaft.

How is the clutch adjustment? How much free play?
12-24-2011 09:54 PM
OMARS67 Yeah I replaced the pilot and throw out bearing. Should I disconnect the reverse first befor the other gears. Didn't think I had too being I didn't remove the tranny or linkage.
12-24-2011 09:43 PM
tjet When I did the clutch on my '71 Vette, I had to disconnect & remove the shifter, but it's a Hurst.

Put it in netural, & disconnect the linkage at the trans. If the linkage on the trans moves or spings to the detent when the linkage rod is disconnected, the linkage will need to be adjusted.

Did you replace the input shaft pilot bearing too? Some are too small
12-24-2011 09:37 PM
OMARS67 Didn't think I had too never disconnected anything on the tranny
12-24-2011 07:13 PM
tjet Did you try disconnecting the linkage to see if it's adjusted properly?
12-24-2011 07:09 PM
OMARS67
muncie stuck in reverse

replaced the clutch and flywheel on my 73 vette before i put my new motor in. now problem is the car is stuck in reverse. when the motor is on i have to keep the clutch in or the car will move back. shifter moves though the other gears when motor is on.its even in reverse when i put it in other gears. when the motor is off i can shift through the gears but wont go into reverse. any help please

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:16 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.