Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Suspension - Brakes - Steering> S-10 Steering Sustitutes
User Name
Password
lost password?   |   register now

Thread: S-10 Steering Sustitutes Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-16-2013 09:25 PM
sbutler Having the same problem as you but with a 39 Ford. This post is a year old so you may have solved your problem. I am notching out the top of the crossmember on that side and re-boxing it so I will have a decent shot at the steering column. Steve
01-14-2012 09:03 PM
StreetKruzer
Vega Box For S-10 Swap ?????

Have Pretty Much Ruled Out Using A Rack & Pinion At This Point Without Swapping To Completely Different Front Suspension. Still Considering Swapping To A Vega Box Instead Of The Stock S-10. Any Suggestions Or Experience With This? Have A New Vega Box And It Looks Like The Arm Length Is The Same. Will Post Some Close Up Pics.
01-12-2012 07:52 PM
StreetKruzer
Pics Coming

Will Try To Get Some Pics This Wknd. Have Mated Engine & 700r4 For Mock Up, And Will Survey The Steering Issue Again With Engine In Place. Thnks C-cab
01-11-2012 08:39 PM
C-cab dreamer There's no doubt that's going to be fun to work out.

Is there any room if you use a two piece link from the bottom of your steering column to a rack? You would need a pillow block (or two) on the frame at some point to keep things in line.

Can you get a few close up pics of the whole setup?
01-11-2012 08:11 PM
StreetKruzer
Thanks For The Reply C-cab

Yes, Need To Lighten The Front As Much As Possible. As Far As Changing Steering To A R & P, Would Luv To But: I Channeled The Front Of The Body About 4 Inches Over The Frame Which Will Make It Even More Of A Challenge To Get To The Box On The Rack Because A Straight Line From The Steering Column To The Rack Would Pass Directly Thru The S-10 Suspension Just Inside Of The Coil Spring, Below The Top A Arm And Above The Bottom. Too Much Gyration For U-joints. Back To The Drawing Board For Me. Perhaps I Do Another Season Or Two With The S-10 Front & Then Bite The Bullet And Cut It Off!
01-11-2012 06:40 PM
C-cab dreamer Well, this is sort of a multiple question really...you seem to be more concerned about keeping the front end light than anything else. Correct me if I'm wrong here.
The safety aspect should go without saying, so we must assume that whatever you do will have that in mind.
I'm not quite sure whether switching steering boxes will help you much, I would be more inclined to go for a R & P setup.
That little red T you see had a Honda R & P installed and I hooked it up to a Buick front end.
You may well be right about getting the steering shaft up to the rack, but with two U-joints it should be quite possible.
I found that the steering with the Honda rack was excellent...power might have helped when parked, but when rolling it was just fine.
01-09-2012 08:30 PM
StreetKruzer
S-10 Steering Sustitutes

I Purchased A 33 4 Dr Ply Street Rod That Has An S-10 Front End Grafted Onto 2x4 Frame Rails. I Want To Lighten The Front Without Sacrificing Any Safety. Can I Swap A Vega Steering Box For The Stock S-10, Or Has Anyone Gone Rack & Pinion? Looks Like It Would Be Difficult To Get Steering Shaft To The Rack. I Have Smoothed The Graft Both Front & Rear, So I Would Rather Keep It On At This Point. It Is Sbc Right Now But Plans Are For Blown Bbc In A Year Or Two. Will Need To Lighten As Much A Possible. Original Owner Backed Off Sway Bar To Top Of Threads, Do I Even Need It & All That Weight At This Point. Car Rides Decent And Doesn't Lean In Turns Or Wind. Appreciate Any And All Suggestions, Etc.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:34 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.