|Today 12:14 PM|
|Today 12:13 PM|
|Today 11:58 AM|
|Trophyman||Yep. Looks good, common place for our vehicles.|
|Today 10:56 AM|
had to celebrate Woo-hoo!
Just finished working out the headers/steering linkage dilemma on my '39 and had to share with someone. Now if I can find a PS Pump bracket that works...
|Today 10:51 AM|
|Trophyman||Ur right, it was a post from somebody else. Thanks for the fuel line tip.|
|Today 09:39 AM|
I drilled an 1/8" hole in each end of the piece of fuel line, I fed the wires through it, placed it in the jam then the door. Then I ran wire ties thru the holes that I had drilled. Now both ends will not come back out and it just slides back and forth.
I am not putting bear claw latches in, you must have read a message that was left on my profile page by someone else.
|Today 07:05 AM|
I see from your profile post that your going to install bear claw latches. I did it on mine and gotta tell you, it wasn't a simple job. Had to cut the doors up pretty good to get the latches where they needed to be. I actually had the latches welded in and had to cut them back out to re-position. Striker in B pillar was no picnic as well
Got a lot of pictures of the process if needed.
|Today 06:39 AM|
|Today 05:28 AM|
I guess I will just leave this here
It's a cool pdf for 38s
|Yesterday 10:09 PM|
|Yesterday 08:55 PM|
|Yesterday 08:52 PM|
I was thinking about putting some speakers in them though.
|Yesterday 08:42 PM|
As for the radio "INFOTAINMENT" system that I'm installing in my 39. I'm installing a Pioneer AVIC-8000 NEX In-Dash Navigation AV Receiver. AVIC-8000NEX - In-Dash Navigation AV Receiver with 7” WVGA Capacitive Touchscreen Display | Pioneer Electronics USA
Building a box for a Kenwood 8" sub with Excelon amp. Focal Performance 165AS component speaker system with Audison voce series amplifier in the front. 2 I'll be able to integrate my back-up camera into the NEX display also.
This big car is getting a lot smaller the more I add.
|Yesterday 06:55 PM|
when i started this thread, i didnt realize how much the 39 had in common with the 37 and 38, or i would have included it in the title.
share lots and often, we love pics
|Yesterday 04:47 PM|
i got some work done to the speedo today.cleaned the cup,light sanding removed any surface rust,etch primed it and let it dry.straightened the bezel by cutting the right size hole from a piect of mdf,dropped the dezel in and gently tapped down the bumps with the back of a punch.
painted the cup inside n out with an off white gloss.later when it was dry i gave it a trial run,happy out with itoffered it into the dash even happier now.hopefull of getting new windows to light the interior
soon. the third gauge is rebuilt and stashed away . wont be fitted until last in case of damage to the line and probe
|This thread has more than 15 replies. Click here to review the whole thread.|