Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> ford 9 bolt rear end crush sleeve install
User Name
Password
lost password?   |   register now

Thread: ford 9 bolt rear end crush sleeve install Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-25-2012 01:53 PM
lmsport The spacer goes between the two bearings,there is only a very thin .030" washer between the yoke and the front bearing to act as an oil shield.
01-25-2012 11:26 AM
Studedean
ford 9 bolt rear end crush sleeve install

Anyone familiar w/ putting a crush sleeve in behind the yoke on this rear end?
Ive got a lincoln versailles 77 rear end. I replaced the circular yoke with a standard one and was very careful when ratcheting back on the nut...BUT its leaking now likes theres no tomorrow.
I imagine if I drain the rear end, take off the nut holding the yoke, the leaking sleeve / washer is in there and its crushed to far.
The replacement came in two pieces??? is there one behind the yoke on the outside and one on the inside, or do they both slide in behind the yoke. WAs hoping to not take all the nuts out of the front of the rear end to replace the one that might go in there.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 05:53 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.