|Yesterday 09:18 PM|
My "5 minutes" turned into 3 hours! After getting the East wall shelves up, it's time to sort what goes on the shelves and what goes "somewhere else", as well as what goes in the "get it OUTTA here" pile!
Got a bunch of stuff in the "Throwaway" pile (stuff like the 2 boxes of old doorknobs from when I upgraded all the hardware in the house) Bunch of stuff to goodwill, bunch of stuff to the garbage.
Spare carbs, cleaning supplies, new Accel distributor in original box all go on top shelf, along with a complete street rod wiring kit that I got for my "Henway project".
|Yesterday 08:27 PM|
|tech69||always nice to think you have primed all the parts and get into the car and see the chain guard sitting there in bare steel. So I guess I'm not done after all. Getting close though. I'll prime the chain guard Monday night at a buddy's warehouse. I think I'll start lacing my rims up tonight now that everything is sitting in primer. At this pace I'll be spraying the frame and all the red parts next weekend. Can't wait! If I don't get done for autorama there's a bike show in June and I'll take it there. Now we just need the 49ers to start winning and our quarterback to focus on throwing the ball, not lifting weights.|
|Yesterday 07:41 PM|
|DRS50||Worked on fabbing up the panhard frame mounting bracket on my jeep project and got it tack welded in place. Measured the panhard bar and cut and threaded it for the bushing end. Got it mounted up and rear end centered up in the frame.|
|Yesterday 07:22 PM|
I got the spring bushings all done and they are looking good. I got the U joints and drive shaft out and my old buddy came by right at the right time and set me straight on how to measure them finding out they are the much cheaper 1" ones, whooo hooo.
I'll get Marge back on the road next week and can't wait to see if that vibration is gone. Of course hopefully the squeaks will be with the new bushings.
Now..I am headed off to San Fran to see Angela Lansbury in "Blithe Spirit" http://www.san-francisco-theater.com...the-spirit.php with the wife. Not much makes me happier than going to the theater with her. We both love it, she was in a few plays in college and really enjoys going so seeing her happy is of course the most important. And she will be happy that's for sure.
|01-29-2015 11:06 PM|
I got the gas tank in Marge, sorry no photos. I know you perverts only want to see her behind!
Tomorrow I hope to get something done, be it small. My daughters final play off game is tomorrow, GOOOOOOOOOO Spartans!
|01-29-2015 11:00 PM|
Picture promised of how we left the '67 Camaro last saturday
|01-29-2015 06:40 PM|
just picked up my hoops/hubs from the powdercoater and later I'll put some finishing touches on the hoops/hubs and then file the holes a bit so I can get my spokes in there and start lacing it. I can't wait to see what it's going to look like. I kind of regret not getting the powder coated gold spokes but the slightly yellowed gold anodized spokes will hopefully look good anyways. I anticipated it and sort of rolled the dice on it to be different.
I'm off. Hopefully that jerk from last night gets the point and gives me my space cause this isn't work and I don't have to put on a smile and ignore it.
|01-29-2015 06:33 PM|
Back on the '68 Camaro today. Got the under dash area rattle can painted satin black so we could mount the vintage air heater unit. No AC, just heat, as it's Oregon, and AC wouldn't help much in a convertible. Plus he doesn't want the compressor load on the engine. Got the heater installed, and that plumbed, but no wiring. Also got a couple small patches done on the under side of the cowl, where water must have built up in the drains at the bottom of the drops.
Here's a peek at the old dash top with entire edge rotted off. And the new dash top installed. And another of the engine and front suspension.
|01-29-2015 10:30 AM|
|01-29-2015 09:10 AM|
|01-29-2015 08:44 AM|
Good job Brian. She deserved that.
|01-29-2015 06:52 AM|
There are knucklehead haters everywhere. It's not happened to me, mostly because of how I carry myself, but have been witness to it on many occasions. The problem is, taking the high ground and ignoring them seems to send the wrong message that you're a punk. You run the risk of being labeled a "trouble maker" if you react to the haters "passive aggressive" attacks.
You're probably handling it the best way, I do wish you luck though.
|01-29-2015 01:25 AM|
finished off the front fender on my bike and am happy to know the rest of the week will go easy with just prepping.
Tonight this know it all old man must have been having a bad day cause he tried to take it out on me. I guess when you don't stand around talking everything down and are quiet and working and able to put your ego to the side to do any task asked of you, these old farts seem to think they can talk down on you. Let's start with day one meeting this chump...The first words he said to me was, "at least you speak english." I just ignored it. Then the other day my buddy asked me to blow off a car so I blew it off and he said, "you missed a spot." I didn't miss a spot he was just being an arse. Then today he turned his head right as I came to the shop to avoid saying hi and then later I was prepping these parts I primed. Low end motorcycle job. My buddy hung up the blasted tank to be sprayed. Sure I noticed the little bit of glue under the emblem left behind, but I didn't hang up the tank and my buddy does low end and high end jobs and a lot of questionable things I wouldn't do, so I sprayed it like he asked. So this idiot asks who primed it. I said I did and he asked why I didn't take off the glue. I told him I didn't hang it up, besides, I saw him take the emblem off and he directly hung up the tank so when he asked me to spray it I did. Then he made some smart remark about how I should have done it anyways. Then later I'm blocking this frame off restoration and he's sitting there staring at me looking for the next thing to say. Then tells me I should edge my block. At that point I wanted to tell him to get the futch out of my face but I told him I use that technique but want to use the teardrop and he smirked and said something smart so I said, " the last car I blocked was a 200k car, I know how to block." He got mad and left. That would be the last straw. The next time he tries to disrespect me I'm not going to be nice about it. Other than that a great day. Not dwelling on that idiot.
I have more important things going on in life than to worry about an old washed up hater.
|01-28-2015 10:27 PM|
|01-28-2015 10:05 PM|
I got the trunk sprayed, WHOO HOOOO!
But as I am looking at the photo I spot that I dripped some paint on the license plate, CRAP.
But other than the judges knocking off some points at Pebble Beach Concourse d'Elegance for a non original modification, it looks good.
|This thread has more than 15 replies. Click here to review the whole thread.|