Hot Rod Forum banner

SBC Header kit

6K views 3 replies 2 participants last post by  Choptop26 
#1 ·
Hello all
I don't post on here much but read a lot of good form posts. I wanted to ask around to see who you thought made a good header kit. I know I will have to make mine for my blown Anglia. My frame rails are marrow (20") and they will need to go on the outside of the rails.
Thank you for any help.
Scott in Ky
 
#2 ·
I just built a set of long tube headers for my coupe with a kit from Speedway. Nice quality materials . The flanges are good and thick . The pre bent tubes were all bent accurately but there were some die marks on them . At least mine had some marks . They might not all have them . Mine is the only set I've seen . I also had to build my own because nothing off the shelf would fit and I ran them down the outside of the frame rails . I just got them back from getting them ceramic coated and I'm very happy with them . I will try to get a pic and post it . I would not hesitate to build another set with the kit from Speedway . I hope this helps you some .
 
#4 · (Edited)
Trying to post the pics . We'll see if it works . Would look better on my engine but it is still at the machine shop . You can see the " die marks " in the second pic . Not a big deal to me since my car is a driver but that is up to the individual . I guess you could call Speedway and ask if they all have them . I might have just gotten a set from a bad run . Hope this helps . Choptop
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top