Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Electrical> how do you do it alternator
User Name
Password
lost password?   |   register now

Thread: how do you do it alternator Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-04-2012 05:07 PM
EOD Guy Here's a dia for a old chevy, ext reg, type alt.
03-04-2012 01:53 PM
stevekz
understood

I actually made real parts by using a standard female clip which fits the blades perfectly.I put a "ring end where it attached to the alt.lug. On the blade furthest from the alt. lug I ran a wire with the correct ends to the toggle switch which sends power to the dist. when in the "on" position. I am sure I am missing something.Everything worked before I started the rebuild last fall. thanks for input.
03-04-2012 01:26 PM
T-bucket23 For short term you can connect the large post to the battery and jumper to both smaller posts. This will force it on. You could switch power to both small terminals and this will also work. You can buy those alternator pigtails for about 5 bucks.
03-04-2012 01:12 PM
stevekz
no marks

I don't have any marking that say 1 or 2 so I hooked it up the way the diagram looked but the battery did not charge.Would it matter if the terminals were reversed?
03-04-2012 09:35 AM
EOD Guy large lug on the rear to the battery, terminal #1 on the alt to the run side of your toggle switch, terminal #2 on the alt to the large lug on the alt....... about as simple as it gets.
03-04-2012 08:53 AM
stevekz
how do you do it alternator

My 1st gen. 350 SBC is on a run stand I made and the engine runs and all the wiring is right so far...but I want to hook up my alternator now and want the simplest most direct wiring I can use.I really don't want to take the wires out of my Z(which the engine is going in).I currently have two toggle switches(one for power to starter button and one to electric fan)Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 01:20 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.