|Today 02:54 AM|
Well, good news on the mower last night. It runs, so I know that the ignition system is still good. This evening it will get run long enough to get hot, check the charging system, and then the oil will get changed. Time to cut grass again already. I'm still trying to make up my mind on the new mower. So many very similar choices... Oh yeah, the fuel line runs right through where the fire was, and it was charred pretty good. When I started removing the burned harness, it crumbled letting the gas in the line come out. We were very close to a major fire last week, I think the Lord had his hand over my daughter that day.
|Yesterday 07:58 PM|
|idrivejunk||I'd probably have to go with the old standby: "How many of your sisters had to hold yer britches while you jumped off the house tonight?"|
|Yesterday 07:57 PM|
|Too Many Projects|
|Yesterday 07:30 PM|
Today felt like work. I was out of stuff at home so just ran to the store in The Loud One. She got "Nice car!"-ed and gawked at, and I got a favorite cashier. The one with the pants so tight that... well... how does she even put those on? I'd like to know! Or help!
Anyway- A warm summer evening rip-snort in your favorite old car while the sunset is just right is just good therapy.
|Yesterday 03:38 PM|
It si the tan with white stripe that goes to pump in tank and the other end goes to any 12v constant source it will run without oil pressure switch cutting it off,,,Or Should,,
But your dog has already won this hunt ,so it don't really matter
|Yesterday 03:24 PM|
|Too Many Projects|
|Yesterday 03:16 PM|
Back to car stuff
|Yesterday 03:02 PM|
|Yesterday 02:31 PM|
|Yesterday 01:41 PM|
Only bending light weight materials no rollbars,,just bracing for hood and radiator cradle,etc,
I don't like the butted and welded tubes ,I want the main tube 1 piece
if it collapses tubes ,I will fill them with sand then the bends will be smooth and no reduction in size,like the Good exaust tubing
|Yesterday 01:03 PM|
|Yesterday 12:55 PM|
|deadbodyman||Finally, after sitting for three solid years and the last 6 months outside I got my old Plymouth in the shop. My helper and I have been working on it for the past 3 days. Whoo Hoo.|
|Yesterday 12:45 PM|
I never could get it to bend anything but it kinked everything really well.
|Yesterday 12:18 PM|
This was posted todat 8/25/2016
Head on don to your favorite Chinese restaurant..lol
Asian Seafood Raised on Pig Feces Approved for U.S. Consumers
At Ngoc Sinh Seafoods Trading & Processing Export Enterprise, a seafood exporter on Vietnam’s southern coast, workers stand on a dirty floor sorting shrimp one hot…
|Yesterday 10:35 AM|
Well a few goodies I had on ebay sold last night, my torch regulators will be leaving tomorrow for rebuild!
|This thread has more than 15 replies. Click here to review the whole thread.|