Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Polishing aluminum
User Name
Password
lost password?   |   register now

Thread: Polishing aluminum Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-19-2012 11:22 AM
revspan thanks for the advice. After thinking about it, I am going to fit to size and then powder coat. Seems like it is a much easier solution with low maintenance..
04-16-2012 03:34 PM
1971BB427 Stainless is so nice when polished, but also really hard to get to that level of finish. I've found the new chrome powder coating looks very nice, or clear powder coating over polished aluminum to keep it looking new.
04-16-2012 12:37 PM
boatbob2
Polishing.........

I had a part made of aluminum that i had to polish all the time,i finally made a part of S/S,polished it 1 time,and it still looks good.
04-16-2012 10:34 AM
1971BB427 There are also some polishing compounds that will help get it looking really great once you get down to the final polish. Get a polish for aluminum and apply it to the metal before buffing.
04-15-2012 08:56 PM
hp246 You don't mention the thickness, but if it is real thin it helps to use wood screws and screw it down to a piece of plywood or 1 X 2. When you are buffing, it will help keep the stuff from twisting.
04-15-2012 07:53 PM
swvalcon Sand it just like you would a clear coat paint working up to a real fine grit like 1500. Best to use a da sander but you could do it by hand all depends on your arm. Then buff with rubbing compound untill you get the gloss you want with a buffer. I've done semi tanks and wheels this way. Expect to get kind of dirty and have black compound grit all over you.
04-15-2012 07:16 PM
revspan
Polishing aluminum

I am going to be polishing some aluminum angle that I got for thresh holds on my truck project. I am going to polish them, and was wondering if anyone has any ideas on doing the polishing. The material I got looks like it might need some minor sanding to get the extrusion marks out. Anyone have recommendations?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 01:03 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.