Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> Wilwood Tandem master Cylinder Question????
User Name
Password
lost password?   |   register now

Thread: Wilwood Tandem master Cylinder Question???? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-22-2012 05:27 PM
cucumber1949 Came out to 5:1 on the pedal ratio. Could have done more by fabricating new parts, but it worked out okay with what I had.
04-22-2012 12:52 PM
JMBO Thanks for the info. What did you finally go with for a pedal ratio?
04-22-2012 08:58 AM
cucumber1949 I had the 1" initially on my T-Bucket, then changed the pedal ratio, and then went to the 7/8". The car has 11" disks up front and drums on the rear so there is plenty of stopping power. These changes all reduced the pedal effort as well as finally 'softening' the pedal for an overall nice feel and effort. I always warn those that want to drive the car that these are not power brakes so be ready - most folks have no experience with manual brakes or don't remember what they were like years ago - expect that just resting your foot on the pedal like they do in their daily driver is enough to stop the car.

However, the proper deteriming factor is the disk caliper volumes you'll be running front and rear and how those match up to what the master will provide. I believe that once you verify the volume requirements, then you can address the bore size.
04-22-2012 08:11 AM
JMBO
Wilwood Tandem master Cylinder Question????

Wilwood Tandem master cylinder question
Trying to spec out a master cylinder for my "A" coupe. Am running Mustang II front discs and Jaguar center mount discs in rear and hope to run a manual master. Have read a lot of posts on the subject of master cylinder bore sizes for a manual application. My question has anyone had experience with the Wilwood Tandem Remote master cylinder in a similar application. The 1" bore seems to be the one that is most readily available. Is that best of should I go for 7/8"?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:35 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.