|05-05-2012 11:11 AM|
|dinger||Check these guys out, used their set up on mine, a friend that builds a lot of chassis's swears by them. http://streetrodengineering.com/|
|05-04-2012 03:18 PM|
1941 Ford crossmember
|04-28-2012 08:38 PM|
1941 ford mustang II -who's crossmember is the best?
my next project will be a 47 ford with a 41 front clip
I've read that the 41's sheetmetal is somewhat narrower than the 46- 48's and that sometimes narrowed control arms and careful front wheel choices are important..
I would like the front wheels to be tucked in as tightly as possible..
currently I have all the stock mustang II parts necessary to do the job, (except for the cross member itself) and I believe I even have a set of airbags to fit in place of the springs... :-)
sadly I dont have a stock 41 front axle.. (or any stock style front end parts for that matter)
I like the chassis engineering front cross member (the bolt in feature would make it go together quickly) however I am wondering if I might be better served with a slightly narrower cross member mady by someone else..
search turned up lots of thougths.. just need some real world experience..