I'm really new at this! Please excuse my ignorance!
I dropped off my flat tappet block this week.
Having it rebuilt with hyper pistons (not sure what kind), elgin cam with .45 lift(what they offered with build). It was a performance build from dependable engine shop in town. Ordering stock GM Vortec heads from Jegs or Summit, RPM intake.
Ok, so I have read SOOOO much about what to do. Need help with order and specifics, if ya can.
1. I don't really need Air Gap right? Just RPM 7116 (per techinspector1, if I remember correctly)
2. Will intake have same bolt holes for brackets? It is the first two holes from the pulleys..
3.Ordering head/intake bolts. What kind? Prices range from 25-100+.. looking for just affordable.
4.This is the most important I think. I'm almost sure there was a specific head gasket for my application to keep compression to 9.5??? Again, I show my ignorance.. Just want to run regular gas.
I don't know what my bore size is. They said it should be around .30 or .40.
Any help is always appreciated!
I dropped off my flat tappet block this week.
Having it rebuilt with hyper pistons (not sure what kind), elgin cam with .45 lift(what they offered with build). It was a performance build from dependable engine shop in town. Ordering stock GM Vortec heads from Jegs or Summit, RPM intake.
Ok, so I have read SOOOO much about what to do. Need help with order and specifics, if ya can.
1. I don't really need Air Gap right? Just RPM 7116 (per techinspector1, if I remember correctly)
2. Will intake have same bolt holes for brackets? It is the first two holes from the pulleys..
3.Ordering head/intake bolts. What kind? Prices range from 25-100+.. looking for just affordable.
4.This is the most important I think. I'm almost sure there was a specific head gasket for my application to keep compression to 9.5??? Again, I show my ignorance.. Just want to run regular gas.
I don't know what my bore size is. They said it should be around .30 or .40.
Any help is always appreciated!