Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> Pistons are .032" in the hole
User Name
lost password?   |   register now

Thread: Pistons are .032" in the hole Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-17-2012 08:26 PM
LATECH Piston pin height (compression Height) can change from different piston manufacturers. You may have an engine that was rebuilt at one time and "rebuilder" grade pistons were used. When replacing them, be sure to check the spec on the compression height to be sure you get them as high up in the hole as you can. Then you can decide to deck or not to deck and what thickness of head gasket you want to run.
One good thing is that the block must be pretty square. If you checked all 4 corners with the same piston and rod and it was the same , it must be square. Also by using the same piston/rod to measure all 4 corners you removed any variance from the measurment than could exist between the entire set of your rods and pistons. Good lookin out.
06-17-2012 08:07 PM
Pistons are .032" in the hole

Tearing down one of my 400 small blocks and measuring the installed height of my pistons and every corner is .032 in the hole. Just wondering if anyone else has had them this bad. I used the same piston and rod for each corner. I usually get .022 to .025.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 02:02 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.