|09-04-2013 05:22 PM|
|AvantiTom||Ugh.. not easy finding connectors to fit these Dorman switches. I assume there are multi-pin sockets that slip on them, but I'd like to find something to fit the pins individually. Any ideas? Thanks!|
|08-26-2013 06:53 PM|
This thread has helped me enormously!
I'm attempting to modify my '63 Studebaker Avanti's power window system with newer and stronger motors for the 15lb windows. With newer, two wire motors, I had to get new switches and Dorman was clueless when I emailed them for a schematic.
Thanks so much, Guys! This info will really help.
|06-19-2012 10:04 PM|
Thanks for the schematics guys, VERY helpful
|06-19-2012 06:05 PM|
|EOD Guy||My translation of the wire dia|
|06-18-2012 11:30 PM|
I used 1983 Chevy C10 pu (which used these switches) as a basis, and found the wiring diagram for you ... see attached.
|06-18-2012 10:05 PM|
The attached schematic should help when you OHM the switch.
|06-18-2012 09:56 PM|
|62restomod||yes,that looks like the same switch|
|06-18-2012 08:21 PM|
|EOD Guy||Does it look like this?|
|06-18-2012 06:55 PM|
dorman 49241 & 49242 switch wiring
bought Dorman pwr window switches(chrome square) for my coupe project, 1 single button switch for the trunk (5 pin and 1 two button for the pwr windows). I bought AC Delco sockets and pigtails for the switches. Each pigtail has 12 ga. wires all the same color. I ohmed out the single switch and thought I had it correct but promptly fried both the switch and connector when I tried it.
Does anyone have a schematic showing the hot/ground/motor connections for the double (6 pin switch)? The pin orientation is:
O O O O
The pin location looks correct as I type but when I preview the post the bottom 2 are out of position. The lower posts are direct below the corner posts on the top row.
The 4 pins on the top row all have continuity between them when the switch is in the normal (at rest) position.
In case anyone needs them the ACD part #s for the pigtails are PT188 and PT 254.