|07-02-2012 01:12 AM|
Much better cam for your tunnel ramed big block would be the comp 294s solid lifter version magnum cam.
The solid cams work a lot better than hyds in this rpm level, in BBC's
the valvetrain is much heaveier than a SBC.
If you want max performance from your BBC use a street strip solid lifter cam
over a hyd.
The 294s cam or something in that ball park is just right.
EG Lunati street strip mechanical UD harold design cam
Be sure to use the right valvesprings, reguardless
These cams are street strip friendly powerfull cams just right for your
street tunnel ram BBC.
The 292H cam is good but these Lunati/UDHarold solids will outperform it.
These cams are easy to maintain.
|06-27-2012 12:41 PM|
I beg to differ, I have done a set of Squirvel ports on my dads 496....although you are right not much material on the roof BUT enough to make the top of the port Square and the bottom I left Oval...and it works really to good, as he already damaged the TH400 whitch had all new clutches re-built, and has recently switch to a bulletproof TH350 with a brake...it will be running soon and i will take pics/vid of the car so all might see what the "sqirvel ports" can do with port work
|06-03-2012 08:30 AM|
|martin7844||Hello Fellow hot Rodders. Thanks for your valuable Information. If there is not enough spare metal in the oval port head to "Port out", and If the super stock drag Racers in the 70's ran rect port intakes to their Oval port Heads. Well NO WORRIES!!! I'll but the rect port tunnel ram Intake for my 69 BBC oval port heads. THX again for your help. I'll keep you posted as to how this engine RUNS.Cheers, Marty.|
|06-03-2012 08:21 AM|
The Super Stock drag racers in the seventies used rectangle port intakes on oval port heats on a regular basis. I've built a few street/strip BBC's this way and have seen no ill effects. As stated, Just use the rectangle port gasket.
|06-03-2012 12:22 AM|
|06-03-2012 12:00 AM|
Porting 396 chev oval port heads to rectangular port
Hello. Fellow Hot Rodders. I have a 1969 Chev BBC with original Oval Port heads. Can I port-grind out enlarge the oval ports to match a rectangular port tunnel ram Intake, with two 650cfm carbs. I also want to install a Comp Cam 11-213-3 Magnum Hydraulic flat tappet camshaft with .550 " int./ .550 exh. lift, & 292 duration. Will this set up dramatically increase my HP & torgue. THX, Marty.