|07-08-2012 08:59 AM|
To check the mechanical advance, use a timing tape or a dial back timing light and accelerate the engine until the mechanical advance quits advancing. The reading there is the total timing. The total timing for most SBC engines should be around 36 degrees, less for Vortec or 'fast burn'-type heads.
If you want to know how much the vacuum advance adds, attach the vacuum line to the vacuum advance and at idle take a reading. Disconnect it and take another reading. The difference between the two is the vacuum advance. Usually you need about 10-12 degrees from the vacuum advance. Stock vacuum advance cans often add more than that.
The combined advance (mechanical plus initial plus vacuum) should fall somewhere around 50 degrees under light throttle cruise conditions (engine vacuum high, throttle setting relatively low).
More on timing here, including how to make a timing tape and how to tell if the timing marks are accurate.
|07-08-2012 07:23 AM|
If you want to check the "total advance" leave the vacuum hose connected and rev the engine to about 3,000 RPM's and either read the timing light gauge OR what's on the timing tape/marks on the balancer (if so equipped).
Check the mechanical advance by disconnecting the vacuum and reving to 3K and reading the light or the timing tape.
|07-08-2012 04:56 AM|
Yes, remove vacuum advance hose and plug the carb where it hooks to. Lower the rpm then check timing. If you have points, check the dwell first, then the timing mark.
|07-07-2012 08:18 PM|
|07-07-2012 04:47 PM|
|68NovaSS||Depends on what you want to check, total timing, vacuum advance, mechanical advance, initial, what rpm it's all in at, etc.|
|07-07-2012 02:40 PM|
1964 Chevy 327 Small Block Timing
I'm interested in just "checking" my timing mark on my 64 Chevy smallblock, do I still need to plug the distributor vacuum hose? I don't plan on adjusting at this time!