Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Electrical> dome light
User Name
Password
lost password?   |   register now

Thread: dome light Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-12-2012 07:23 PM
chevyhed53
dome light

Thanks for the reply. I did just as you suggest--ran it under the floor, drilled a hole, put in a grommet and put a toggle in line right where my left hand falls behind the driver's seat.
07-12-2012 06:24 PM
jmacs53Willys You can always go with a grommet through the floor , under the cab and then back into the cab if you can get to the floor? Of course you will want to use some plastic wire wrap to protect the wire from the elements and whatnot. Remember that if you want to use door buttons to activate the light, the buttons are the ground side of the light. That way there is no positive power at the door button, it just makes the ground for the light when doors are opened. Your power can be from a full time fused positive terminal, switched or unswitched, or like you want, a toggle. If you are just going with a positive and a negative two wire install then passing the wire through the back of the cab will have to be basic wiring 101. Hope this helps. Jmac
07-05-2012 09:34 PM
chevyhed53
dome light

An addendum: I still have my gas tank behind the seat, so there's no way to access it by dropping it straight down behind the driver's seat.
07-05-2012 09:33 PM
chevyhed53
dome light

OK, here's a weird one: I need to rewire the dome light in my '56 Chevy stepside. I don't want to wire it to the headlight switch, instead I'm just going to put a basic toggle switch on it. Problem is, I ran mechanic's wire as far as I could through the hole where the original wiring came through on the light fixture, and I can't make any progress--in other words, I can't figure out where to run the wire to power. I assumed it snaked down behind the driver's leftshoulder (more or less) and under the running board and up into the firewall. But I can't do it. Any suggestions? Thanks!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.