|08-16-2012 01:14 AM|
Using a flat tappet magnum cam,hydraulic lifters.
Looks like the roller rockers and studs were chinese,no name on box and slightly different to my mates ones, dont think that surprises some of you guys!!
|08-15-2012 11:24 PM|
|68NovaSS||You'll need to get the feel of that extra tweek at the end on solid cams, it will open the gap some. If you're anal, you can set it a little tight, tweek and check clearance. After a while you kind of get the feel for it. I don't recall what cam you're using.|
|08-15-2012 08:30 PM|
|Richiehd||Dave I guess you got that stud issue worked out? I think Pro Comp or Comp cams makes an adjusting tool with the allen handle mounted on top. Makes adjsuting go a bit quicker. Another note, once you are set, shouldnt take much to adjust them each time. Dont foget that extra tweek when you tighten the locknut, keeps em from backing up.|
|08-15-2012 04:24 PM|
|vinniekq2||dont take the chance of the nuts backing off.adjust,lock,done,recheck if you are not sure.put covers on,go fast|
|08-15-2012 03:01 PM|
when I set the valve lash on my roller rockers can I set all 16 first(obviously in the correct order)then tighten the poylocks down all in one go after?